Basic configuration of Sippy switch (checklist)
DIGEST AUTHENTICATION scenario
№ | Check list with required steps | Done |
| Vendor section menu: | ||
1. | Click Add Vendor (specify: name, currency, balance etc.) |
|
2. | Click action Open Connections |
|
3. | Click Add connection under the new created vendor (specify: name, destination(IP), username/password etc.) |
|
| Routing section menu: | ||
| Enter to the Destination sets page | ||
6. | Click Add Destination Set (specify: name, currency etc.) |
|
7. | Click Open Routes (it is prefixes and prices of your vendor) |
|
8. | Click Add Route or Upload Routes from file (add new prefixes and prices etc.) |
|
| Enter to the Routing Groups page | ||
9. | Click Add Routing Group (specify: name, routing policy (active list), on-net routing (if requires), routing entries list) |
|
Tariffs & Currencie section menu: s section menu: | ||
| Enter to the Tariffs page | ||
10. | Click Add Tariff (specify: name, currency, avg call duration etc.) |
|
11. | Click Open Rates (it is prefixes and prices for your customers) |
|
12. | Click Add Rate or Upload Rate from file (add new prefixes and prices etc.) |
|
| Enter to the Service Plan page | ||
13. | Click Add Service Plan (specify: name, basic tariff, billing cycle, billing type, on billing failure etc.) |
|
| My Customers section menu: | ||
| Enter to the Accounts page | ||
14. | Click Add Account (specify: Account Name, Voip Login, Voip Password, Service Plan, Routing group, balance etc.) |
|
| 15. | Register account on your voip device using the digest authentication | |
| Routing section menu: | ||
| Enter to the Test Dialplan page | ||
16. | Try to make a test of your configuration from the registered account on your device or softphone (register account on your device and make an outgoing call) |
|
Similar checklists that may be useful:
See how to register account for the test call in the following documentation: